disorder.ru

Пришлось немного повозиться, но в целом документации на beagleboard.org и в src/distrib/notes/beagle достаточно, чтобы все сделать. Традиционный dmesg pr0n под катом.

## Booting kernel from Legacy Image at 80800000 ...
   Image Name:   boot
   Image Type:   ARM Linux Kernel Image (uncompressed)
   Data Size:    2634196 Bytes = 2.5 MiB
   Load Address: 80300000
   Entry Point:  80300000
   Verifying Checksum ... OK
   Loading Kernel Image ... OK
OK

Starting kernel ...


OpenBSD/beagle booting ...
probing memory
sdrc_mcfg_0 02584099
sdrc_mcfg_1 02584099
initarm: Configuring system ...
ID_PFR0  0x00001031
ID_PFR1  0x00000011
ID_DFR0  0x00010400
ID_AFR0  0x00000000
ID_MMFR0 0x31100003
ID_MMFR1 0x20000000
ID_MMFR2 0x01202000
ID_MMFR3 0x00000011
ID_ISAR0 0x00101111
ID_ISAR1 0x12112111
ID_ISAR2 0x21232031
ID_ISAR3 0x11112131
ID_ISAR4 0x00111142
ID_ISAR5 0x00000000
about to SWP 0x1234 -> 0 
mem 1234 reg 0
physmemory: 32768 pages at 0x80000000 -> 0x87ffffff
Allocating page tables
freestart = 0x005fa000, free_pages = 530950 (0x00081a06)
IRQ stack: p0x81fd1000 v0xc1fd1000
ABT stack: p0x81fd0000 v0xc1fd0000
UND stack: p0x81fcf000 v0xc1fcf000
SVC stack: p0x81fcd000 v0xc1fcd000
Creating L1 page table at 0x81ffc000
Mapping kernel
Constructing L2 page tables
undefined page pmap [ no symbol table formats found ]
Copyright (c) 1982, 1986, 1989, 1991, 1993
        The Regents of the University of California.  All rights reserved.
Copyright (c) 1995-2011 OpenBSD. All rights reserved.  http://www.OpenBSD.org

OpenBSD 4.9-current (GENERIC) #1: Mon May 30 22:59:52 MSD 2011
    grange@twinhead.home:/usr/src/sys/arch/beagle/compile/GENERIC
real mem  = 134217728 (128MB)
avail mem = 124592128 (118MB)
mainbus0 at root
cpu0 at mainbus0: ARM OMAP3[45]30 rev 3 (ARMv7 core)
cpu0: DC enabled IC enabled WB disabled EABT branch prediction enabled
cpu0: 16KB(64b/l,4way) I-cache, 16KB(64b/l,4way) wr-back D-cache
ahb0 at mainbus0
prcm0 at ahb0 addr 0x48004000 rev 1.0
CM_FCLKEN1_CORE 43fffe01
CM_ICLKEN1_CORE 7ffffedb
CM_AUTOIDLE1_CORE 8
CM_FCLKEN_WKUP e9
 CM_IDLEST_WKUP 200
omgpio0 at ahb0 addr 0x48310000 intr 29 rev 2.5
omgpio1 at ahb0 addr 0x49050000 intr 30 rev 2.5
omgpio2 at ahb0 addr 0x49052000 intr 31 rev 2.5
omgpio3 at ahb0 addr 0x49054000 intr 32 rev 2.5
omgpio4 at ahb0 addr 0x49056000 intr 33 rev 2.5
omgpio5 at ahb0 addr 0x49058000 intr 34 rev 2.5
intc0 at ahb0 addr 0x48200000 rev 4.0
gptimer0 at ahb0 addr 0x49032000 intr 38 rev 1.3
gptimer1 at ahb0 addr 0x48318000 intr 37 rev 1.3
omdog0 at ahb0 addr 0x48314000 rev 3.1
ommmc0 at ahb0 addr 0x4809c000 intr 83 rev 0.0
prcm_enableclock 24: fclk 43fffe01 43fffe01 iclk 7ffffedb 7ffffedb
sdmmc0 at ommmc0
ehci0 at ahb0 addr 0x48064800 size 0x400 intr 77
prcm_enableclock 96: fclk 00000000 00000001 iclk 00000000 00000001
usb0 at ehci0: USB revision 2.0
uhub0 at usb0 "OMAP3[45]xx EHCI root hub" rev 2.00/1.00 addr 1
com0 at ahb0 addr 0x49020000 size 0x400 intr 74: ti16750, 64 byte fifo
com0: console
 prcm_setclock old 00000015 new 00000014 prcm_setclock old 000000ff new 000000fe
/dev/ksyms: Symbol table not valid.
scsibus0 at sdmmc0: 2 targets, initiator 0
sd0 at scsibus0 targ 1 lun 0:  SCSI2 0/direct fixed
sd0: 7640MB, 512 bytes/sec, 15646720 sec total
vscsi0 at root
scsibus1 at vscsi0: 256 targets
softraid0 at root
boot device: lookup '' failed.
root on sd0a swap on sd0b dump on sd0b

Судя по строчке usb0 at ehci0 должны работать USB устройства, так что есть шанс подключить USB WiFi и получить доступ к Интернету. Но это уже буду в следующий раз пробовать.